Hikvision CCTV IP Camera Default Usernames, Passwords and IP Addresses Setting

For EBULWARK customers, what should I do if I forget to log in to the system and password? Like usernames, passwords, and IP addresses are all covered in this article. The information found on this page may apply to a variety of system applications and types (including but not limited to small residential systems, including enterprise/commercial systems, or even integrators trying to help their customers)! If you can't find the Ebulwark service team, the Ebulwark service team can also provide you with a manual. The default credentials are listed for common manufacturer/brand names. If you or someone who has access to the system changes any of the defaults, the default credentials will no longer apply unless the device has been "reset" first. The following is an easy-to-reference chart that I hope will help you. If it doesn't help, please contact us or other unresolved service needs!

 Acti
Username: Admin/admin
Password: 12345/123456
IP address: 192. 168.0.100

Arecont Vision
Arecont does not have a default password , but you can reset it to factory settings. Follow these steps
1-Access the camera's web interface by typing the IP in your web browser.
2-Under the Administration or System tab, click on Restore to Factory Default.
3-Once the camera reboots, all settings on the camera will be restored to factory default

AXIS
For an old system:
Username: Root
Password: Pass
IP Address: 192.168.0.90
But new generation AXIS cameras have a resetting sequence
1-Remove the Ethernet cable
2-Press and hold the control button and insert the Ethernet cable again while holding the control button.
3-Hold the control button until the amber lights turn on.
4-Then release the button .
5-Wait about 1 minute.
6-When the amber lights turns into the green lights your camera is resetted and your passoword as well

BOSCH
For old models:
Username: service
Password: service
IP Address: 192.168.0.1
For new models:
You can reset the camera by pushing the reset button about 7 seconds. Or you can reset the NVR by removing the battery on the mainboard (not recommended, at your own risk)

DAHUA
Username: admin
Password: admin

GEOVISION
Username: admin
Password: admin
IP Address: 192.168.1.108

HIKVISION
For old models (before firmware 5.3.0)
Username: admin
Password: 12345
IP Address: 192.0.0.64
For new models you can reset password via SADP tool. Please click the link below and follow the instructions on the pdf file
Hikvision password resetting guide

LTS Security
Username: admin
Password: 12345 or123456
IP Address: 192.0.0.64
For platinum models please click the link below for pdf file.
LTS platinum series password reset

Messoa
Username: admin
Password: 1234 or model number of camera or
IP address: 192.168.1.30
Mobotix:
Username: admin
Password: meinsm

SAMSUNG Techwin
For old models
Username: admin
Password: 111111 or 1111111
For new models
Username: admin
Password: 4321
IP Address: 192.168.1.200

SONY
Username: admin
Password: admin
IP Address: 192.168.0.100

Speco
For old models:
Username: root or admin
Password: root or admin
For new models:
Username: admin
Password: 1234
IP Address: 192.168.1.7

Ubiquiti
Username: ubnt
Password: ubnt
IP Address: 192.168.1.20
Videocomm
Username: admin
Password: 12345

Vivotek
None . You can choose your own password after setup. If you want to reset it
1-Press and hold down the reset button for at least 1 minute
2-Power on the camera until the red light flashes rapidly
Now your camera is back to factory default without any password.

For other brands usernames and passwords please see below: